Torsion Bar Set – VW 21 3/4" Long (27mm)
SKU 1027
Category: Volkswagen Torsion Bars Ultra-high-performance replacement torsion bars engineered for maximum stiffness. At 27mm, these bars are designed for high-horsepower street cars, heavy off-road builds, or competitive drag racing where preventing rear-end squat is critical.
Performance & Fitment
Application: VW Type 1 (Beetle) & Type 3 (Rear) Length: 21 3/4” Diameter: 27mm (Extreme Duty Upgrade)
Volkswagen Beetle (Standard & Super): 1969 through 1977 (IRS Rear)
Volkswagen Karmann Ghia: 1969 through 1974 (IRS Rear)
Volkswagen Type 3 (Squareback/Fastback/Notchback): 1968 through 1973 (Rear)
Premium Construction
Material: High-strength aircraft-grade alloy steel for maximum torque capacity
Manufacturing: Centerless ground to eliminate surface imperfections and ensure a perfectly linear spring rate
Heat Treatment: Specialized through-hardening and shot-peening to resist high-stress fatigue
Finish: Industrial powder coating for superior protection against salt and debris
⚠️ Critical Fitment Exceptions
Even if your car falls into the year ranges above, you must ensure it does not fall under these exceptions:
❌ Pre-1969 Swing Axle: These 21 3/4" bars are for IRS (Independent Rear Suspension) vehicles. Most 1968 and older Beetles use "Swing Axle" setups requiring much longer 26 11/16” bars.
❌ Harsh Ride Warning: A 27mm bar is significantly stiffer than the factory ~23.5mm bar. This will drastically firm up the suspension; it is recommended for performance applications rather than daily comfort.
❌ Spline Count: These utilize the standard VW 40-spline inner and 44-spline outer configuration. Ensure your inner torsion housing and outer spring plates have not been swapped for Porsche or custom race splines.
What’s Included
(1) Pair of solid torsion bars
Warranty
Backed by a 1-year warranty for peace of mind.
Available on backorder